What to test on: Interaction: Is the interaction smooth and intuitive? Experience: How do users react to the installation? Is their experience valuable? usefulness: Does the installation benefit the user? Goals: Does interaction with the installation help to reach our goals? Data collection: How are we able to extract useful information from the installation? Interaction:…

The User test yielded positive results and good feedback. Everyone enjoyed the screenless interaction and was positive about the turning of the wheel. However we did learn that we need some clarification on how to interact with the installation, this could be done in the form of a little comic or infographic that explains the…

I revised the one pager so that it shows new and relevant information. We elleborated more on the value our installation provides for the customer and the way we gather data. Mark also encouraged us to make work out our concept a bit more to make it well rounded. The customer journey and media should…

After finishing the final construction drawings I was able to complete the list of materials we need for building the installation. I worked them out in a spread sheet. Now I can order everyting and start building. Below are all the materials we needed for the main construction of the installation, however some materials were…

After doing some more thinking we made a few extra iterations on the design. We also had to scale it down since the table we use was 81cm in diameter instead of 1 meter, this meant that some of the parts had to be remeasured and refitted but the general design of the installation was…

After same technical tests regarding the light sensors Kaj came up with an idea that will require a slightly adapted design. The light sensors will be placed on the inside of the lower ring. Then the main ring will be placed over the sensors. This new implementation can be seen in my sketch below. After…

After discussing my first sketches with the group and various teachers I started with creating a more detailed construction sketch. I chose to draw a cross section of the installation with all the measurements included so that we would have an idea of the materials that we would need to construct the installation. I have…

Today I started working on my first construction sketch. It does not yet have the sizes anfd materials worked out. For now my sketch is inspired by of all the ideation sketches that have been made by the group and combines all of them into the final concept sketch to give everyone an idea what…